Filter Installation / Replacement
MicroTech
®
9000 Filter Replacement Instructions
For PureTouch® AquaSuite™ Water Filtration
System, (77100 Series)*
Instrucciones para Reemplazar el Filtro 9000
Para el sistema de Filtrado de Agua PureTouch
®
AquaSuite™ (Serie 77100)*
Directives de remplacement du filtre MicroTech
®
9000
Pour système de filtration de l'eau AquaSuite
MC
PureTouch
®
(série 77100)*
HELPLINE: 1-877-DRINK-H2O LÍNEA DE AYUDA: SERVICE À LA CLIENTÈLE :
(1-877-374-6542) 1-877-DRINK-H2O 1 800 465-6130
Au Canada 1 800 465-6130 (1-877-374-6542)
En Canadá 1 800 465-6130
INS415A 09/05
9. Reset the Filter Life Indicator Module by
pushing the reset button (5) on the Filter Life
Indicator Module.
10. A new filter must be flushed with cold water for
5 minutes after it is installed. This procedure
helps clean the filter of loose carbon particles.
The Filter Life Indicator Lights will alternate
green and amber until flushing is complete.
Once completed, the light will change to
flashing green.
11. Filter replacement complete.
MicroTech Replacement Filters
• Do not use with water that is microbiologically
unsafe or of unknown quality without
adequate disinfection before or after the
system. Systems certified for cyst reduction
may be used on disinfected waters that may
contain filterable cysts.
• Replacement filters can be purchased at retail
home centers, plumbing supply warehouses,
internet retailers and directly from Moen at
www.pure-touch.com.
1. The filter needs to be
replaced when the Filter Life
Indicator Light begins to flash
red. A flashing amber light
indicates less than 8% filter
life remaining.
2. Turn off water pressure by
closing the Stop Valve (1)
(open position shown) next
to the Filter Life Indicator
Module (2).
CAUTION: The Stop Valve
must be closed before
removal of filter.
3. Next, turn the AquaSuite
faucet handle to the full ‘ON’
position for several seconds
to relieve any remaining
water pressure, then turn
back ‘OFF’.
4. Rotate the filter (4) by moving the arrow from
the locked position until it comes to a
complete stop in the unlocked position.
5. Pull the filter down and out of the Filter
Mounting Bracket. It is normal for a small
amount of water to drip from the mounting
bracket when the filter is removed.
6. Remove new filter from packaging and install
by reversing steps 4 and 5 above.
7. Turn on water pressure by opening the Stop
Valve.
8. Turn the AquaSuite faucet lever to the full ‘ON’
position for several seconds to confirm proper
operation of the filter and turn back ‘OFF’.
CAUTION: Air pressurization of the filter
occurs once the stop valve (1) is opened
following a new filter installation. Make
sure to relieve the pressure in the system
by opening up the AquaSuite faucet
valve after you open the stop valve on
the Filter Life Indicator Module.
(6 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals