INSXXX29 - 4/13TWO HANDLE LAVATORY FAUCETMEZCLADORA PARA LAVABODE DOS MANERALESROBINET DE LAVABO À DEUX POIGNÉESPlease Contact Moen FirstFor Installat
AADD123CC 19S19AS19BVerify white plastic pivot rod seat (AA) is in place with beveled side facing out. The pivot rod (CC) can be installed i
INS2230 - 10/13R312225To ush debris from the plumbing system: Remove the aerator by unthreading by hand or by using the included aerator tool (R) p
INS2230 - 10/13©2013 Moen IncorporatedMoen Incorporated25300 Al Moen DriveNorth Olmsted, Ohio 44070-8022U.S.A.Moen Inc.2816 Bristol CircleOakville, On
CAUTION — TIPS FOR REMOVAL OF OLD FAUCET: Always turn water supply OFF before removing existing faucet or disassembling the valve. Open faucet h
INS2230 - 10/13LKGICJHDEFx2 x2 x2 x2 NM E O N P N / 9 9 9 5 1 MOPx2BAQRParts ListA. Handles (2)B. SpoutC. Valve Clips (2)D. Upper Mountin
Waste Assembly Ensamblaje del desagüe Assemblage de la bonde SUVWXYZAABBCCDDTEEParts ListS. PlugT. Lift RodU. Pivot Rod ClipV. Waste SeatW. Drain
INS2230 - 10/13BLMOENP/N 99915M1Apply a small amount of silicone lubricant (M) to the black rubber o-ring on the spout shank (L) as shown.Aplique una
LJOHO5Use mounting tool (O) to tighten the mounting nut (J) to the spout base (L).Utilice la herramienta de montaje (O) para apretar la tuerca de mont
INS2230 - 10/13CC9Slide clip (C) into the groove on each valve body. Check to see that each valve body outlet connection below the deck points toward
GN13Rotate the red stem extension on the hot valve body (N) clockwise and the blue stem extension on the cold valve body (G) counterclockwise untilthe
INS2230 - 10/13Position the drain o-ring (Z) in the groove at the top of the tail piece (BB) and thread onto the waste seat (V). After (BB) is attach
Comments to this Manuals